| |
|
|
|
Specifications
Nominal Size Range
1 " -
8 "
(
25 mm -
200 mm )
Burst Pressure Range
15 psig-
1000 psig (
1,03 barg -
68,9 barg )
Recommended Operating Ratio
90 % of the rupture disc's rated (stamped) burst pressure.
Seating Configuration
Flat Seat |
|
Service
Gas
B.D.I.® Alarm System Compatible?
Yes
ASME Code Symbol Stamp Available?
Yes
Materials not indicated or shown may be available by special design. Contact the factory for more information. |
Accessories
(B.D.I.) Burst Disc Indicator
Continental Disc Corporation's Burst Disc Indicator (B.D.I.) Alarm System is designed specifically for use with C.D.C. Rupture Discs. Upon disc rupture, the Burst Disc Indicator strip is severed, disrupting the flow of electric current through the strip. An attached alarm monitor can then transmit a warning and/or activate appropriate equipment.
More Information
Enviroguard® Pipe End Covers
Protect free vent rupture disc piping and safety relief valve outlets from unwanted foreign material, rain, insects or birds by installing the ENVIRO GUARD® pipe end cover. It is available for 90° or 45° pipe ends and may be purchased with an optional retrieval rope to retain cover near the location after venting.
The Pipe End Cover provides protection from snow, ice, or rain accumulation in open piping, and shields piping so birds or insects cannot inhabit the open vent. It allows visual indication of overpressure relief when the cover is expelled from a pipe. The bright blue fabric is highly visible, even from a distance.
More Information
Heat Shield
Heat Shields are typically used to reduce the process temperature to which a rupture disc is exposed. Heat Shields are used where Teflon® or other exotic material liners are required for corrosion resistance or as part of the rupture disc itself in combination with high process temperature.
More Information
Installation Instructions
Literature
No Literature Found
|
|
|
|
 |
|
